Vizualogic Computer Monitor VL8000 Series User Manual

Visor Installation  
1. Disconnect the vehicle’s negative battery terminal. (Black wire)  
2. Please see Visor Removal Instructions to remove the passenger side visor.  
3. Remove the ‘A’ pillar trim and kick panel on the passenger side and route the Video  
Cable and Ground Wire around the front edge of the headliner and across to the ‘A’.  
4. Install the visor monitor and mounting brackets to the headliner by reversing the Visor  
Removal Instructions.  
5. Route the Video Cable and Ground Wire down the ‘A’ pillar. Use a wire fish to pull the  
cable straight down past the edge of the vehicle’s dash to the kick panel.  
6. From behind the kick panel, route the Ground Wire, under the front edge of the carpet,  
across the vehicle to the Parking Brake. Use the supplied connector to attach the Ground  
Wire to the vehicle wire for the Parking Brake Switch.  
7. Continue routing the Video Cable under the door sill and carpet and  
connect the video control box.  
Vizualogic® Visor System Diagram  
VL8000 Series  
Hummer H2  
VISOR MONITOR SYSTEM  
Copyright © 2003 TMI Products, Inc.  
All Rights Reserved  
Corona, CA U.S.A.  
Installation Manual  
060300  
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584  
Fall 2003  
99-8014-002 10/03  
 

Teac Radio GR 7i User Manual
Tektronix Computer Accessories TVS600 TVS600A Series User Manual
Telex Speaker EVID Ceiling Speaker Systems User Manual
Toshiba Flat Panel Television 20A44 User Manual
Triarch Indoor Furnishings 29644 User Manual
Tripp Lite Surge Protector P052 008 User Manual
Vandersteen Audio Portable Speaker VSM 1 User Manual
ViewSonic Projector PLED W200 User Manual
VTech Cordless Telephone CS2111 11 User Manual
Weed Eater Blower 530088127 User Manual